WD USB MY PASSPORT – CHARGER FAMILY | SLOW DETECTION – SYSTEM HANG, DRIVER LOADING ISSUE | NATIVE SOLUTION, WITHOUT USING ADVANCE FIRMWARE TOOLS

Hello Everyone, welcomes to data Empires. Friends, the latest version of the WD my passport hard disk is, charger family version. There comes many firmware related problems in the hard discs of this family. Generally, due to firmware problems, the hard disc is not detected in the system. And if it gets detected, then it performs very slowly due to which, the system gets hang.
Many times the drive gets detected in the device manager, but it doesn’t open in the disk management.

When we open this hard disk casing, then we find A 3.0 USB connector is connected to the PCB. In the hard disk of the charger family, the MCU has been locked by the manufacturers. And therefore to get the backup of ROM and firmware modules, we require an unlocked SATA PCB. If the Charger family hard disk is not getting detected, then for its detection, there is a need for advanced firmware work. But, if the hard disc is getting detected, and it is working slowly, or it is getting the system hanged, and hard drive drivers are not getting loaded properly, then in such cases, we can recover the data without SATA conversion and firmware repairing.

In this training session, we will discuss how to recover data from the latest WD my passport charger family hard disk, having the problem of slow detection and system hang without using advanced firmware repairing tools and SATA conversion.

dataempires